doc:appunti:hardware:toyota_yaris_radio
Toyota Yaris 2006 Car Radio
- Pull the two side bands, starting from the bottom edge.
- Remove the four screws.
- Unlock the three interlocking snap in at the top: push the tabs with your finger while you pull the frame.
- Pull the radio block, releasing the four mounting pin-push (pink color).
- Release the three connectors and the antenna plug.
Steering wheel commands
There are five buttons at the steering wheel: volume +, volume -, channel up, channel down and mode. At the radio side there are only three wires connected to the 20 pin connector.
Here it is the schematic:
With a multimeter we read the resistance values at the radio receiver connector while pressing each button:
Resistance at SWG - SW1 | |
---|---|
No buttons pressed | 100 kΩ |
Seek + | 0 Ω |
Seek - | 329 Ω |
Vol + | 1000 Ω |
Vol - | 3110 Ω |
Resistance at SWG - SW2 | |
---|---|
No buttons pressed | 100 kΩ |
Mode | 0 Ω |
so we calculated the resistor values:
Steering Wheel Commands Resistors | |
---|---|
R1 | 100 kΩ |
R2 | 100 kΩ |
R3 | 330 Ω |
R4 | 680 Ω |
R5 | 2200 Ω |
doc/appunti/hardware/toyota_yaris_radio.txt · Last modified: 2017/02/19 11:40 by niccolo