doc:appunti:hardware:ups_apc
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
doc:appunti:hardware:ups_apc [2022/10/27 17:14] – [APC Back-UPS CS 500] niccolo | doc:appunti:hardware:ups_apc [2022/10/27 17:37] – [Using APC UPS on Debian GNU/Linux] niccolo | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Using APC UPS on Debian GNU/Linux ====== | ====== Using APC UPS on Debian GNU/Linux ====== | ||
- | I used two different UPS units to provide power to a **Dell PowerEdge T110** (with two 4 Tb hard disks), a **DSL router** and an 8 ports **switch**. The equipments drawn about **62 W**. The first UPS is an **APC Smart-UPS 750 USB** purchased in 2006, the second one is a **APC Back-UPS CS 500** purchased in 2022. | + | My home-server system |
- | The **APC Back-UPS CS 500** should be able to supply power for about 30 minutes; doing battery calibration | + | |
+ | | ||
+ | * An **8 ports switch**. | ||
- | ====== | + | All the equipments drawn about **62 W** during daily operation. In several years I tested the following two APC UPSs: |
- | L' | + | |
+ | | ||
+ | |||
+ | Both units support monitoring through an **USB cable** and the **apcupsd** program, it seems that the Back-UPS CS 500 does not support the periodic self-test. | ||
+ | |||
+ | The **APC Back-UPS CS 500** should be able to supply power for about **30 minutes** to the above system (which the USP itself senses as a 16% load); doing battery calibration with the '' | ||
+ | |||
+ | ====== APC Smart-UPS 750 USB ====== | ||
- | It is used to protect a **Dell PowerEdge T110** (with two 4 Tb hard disks), a **DSL router** and an 8 ports **switch**. The equipments drawn about **62 W**. | + | L' |
Installare il pacchetto **apcupsd**. Per visualizzare convenientemente lo stato dell' | Installare il pacchetto **apcupsd**. Per visualizzare convenientemente lo stato dell' | ||
Line 56: | Line 65: | ||
< | < | ||
- | BATTERYLEVEL | + | BATTERYLEVEL |
MINUTES 8 | MINUTES 8 | ||
</ | </ | ||
Line 92: | Line 101: | ||
^ New battery date MM/ | ^ New battery date MM/ | ||
- | |||
| 08/ | | 08/ | ||
| 11/ | | 11/ | ||
Line 217: | Line 225: | ||
</ | </ | ||
- | The two most important functions are the **battery calibration** and the **self-test interval**. Battery calibration must be initiated with a fully charged battery and a load above 10%; it will end when battery drops below about 25%. | + | The two most important functions are the **#10 battery calibration** and the **#12 self-test interval**. Battery calibration must be initiated with a fully charged battery and the normal |
- | Unfortunately it seems that the **Back-UPS CS 500** model does not support the **periodic self-test**, | + | |
^ New battery date (MM/ | ^ New battery date (MM/ |
doc/appunti/hardware/ups_apc.txt · Last modified: 2022/11/02 16:49 by niccolo