Differences

This shows you the differences between two versions of the page.

--- doc:appunti:hardware:technicolor_tg789vac_v2 [2020/03/18 16:36] – [Router Bircked] niccolo
+++ doc:appunti:hardware:technicolor_tg789vac_v2 [2020/03/23 17:28] – [Router Bircked] niccolo
@@ Line 94: / Line 94: @@
 === Accessing the serial line ===
-I tried also to connect a serial adapter to the **J5** tag, soldering three wires to it. **TX** and **RX** lines should correspond to **R327** and **R328** resistors, according to some posts. But I did not get any serial signal.
+I connected a serial adapter (3.3 v) to the **J5** tag soldering three wires to it. **TX** and **RX** lines correspond to **R327** and **R328** resistors. I connected the three pins to a serial-to-USB adapter using Minicom at **115200 8N1**. The serial console is displayed, but it is in read-only mode, no input is accepted.
+<code>
+Technicolor Gateway
+(c) 2015, All rights reserved
+Decompressing Bootloader................................
+Gateway initialization sequence started
+Boot Loader Version : 2.0.85
+CPU                 : BCM63168-D0
+RAM                 : 256MB
+Flash               : 128MB NAND, blocksize=128KB, pagesize=2048B
+Board Mnemonic      : VANT-6
+Market ID           : FFFCExternal switch id = 53125
+Booting             : Bank 1
+Magic packet        :
+SW Version          : 0.0.0.0.0
+Starting the Linux kernel
+[    0.000000] Initializing cgroup subsys cpu
+[    0.000000] Linux version 3.4.11-rt19 (repowrt-builder@d0b3de64c70c)
+               (gcc version 4.6.4 (OpenWrt/Linaro GCC 4.67
+[    0.000000] VANT-6 prom init
+[    0.000000] CPU revision is: 0002a080 (Broadcom BMIPS4350)
+</code>
 === Forcing a bank switch ===