Differences

This shows you the differences between two versions of the page.

--- doc:appunti:hardware:technicolor_tg789vac_v2 [2020/03/18 16:00] – [Router Bircked] niccolo
+++ doc:appunti:hardware:technicolor_tg789vac_v2 [2020/03/18 16:03] – [Router Bircked] niccolo
@@ Line 102: / Line 102: @@
   * In normal condition, the router boot from bank_1.
   * Flashing via **TFTP** will write to **bank_1** only. It will do so even if the active bank is currently bank_2. It will never set bank_1 as active.
-  * If something goes bad during the kernel load, the router automatically tries to reboot from the other bank.
+  * You can see what is the **active bank** by reading **/proc/banktable/active** or by reading **serial console** output during bootstrap.
+  * If something goes bad during the kernel boot, the router automatically tries to reboot from the other bank.
   * FIXME Is there a software command to switch from bank_1 to bank_2?