doc:appunti:hardware:technicolor_tg789vac_v2
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| doc:appunti:hardware:technicolor_tg789vac_v2 [2020/03/18 16:00] – [Router Bircked] niccolo | doc:appunti:hardware:technicolor_tg789vac_v2 [2020/03/18 16:02] – [Router Bircked] niccolo | ||
|---|---|---|---|
| Line 103: | Line 103: | ||
| * Flashing via **TFTP** will write to **bank_1** only. It will do so even if the active bank is currently bank_2. It will never set bank_1 as active. | * Flashing via **TFTP** will write to **bank_1** only. It will do so even if the active bank is currently bank_2. It will never set bank_1 as active. | ||
| * If something goes bad during the kernel load, the router automatically tries to reboot from the other bank. | * If something goes bad during the kernel load, the router automatically tries to reboot from the other bank. | ||
| + | * You can see what bank is active by reading **/ | ||
| * FIXME Is there a software command to switch from bank_1 to bank_2? | * FIXME Is there a software command to switch from bank_1 to bank_2? | ||
doc/appunti/hardware/technicolor_tg789vac_v2.txt · Last modified: 2020/03/23 17:52 by niccolo