Differences

This shows you the differences between two versions of the page.

--- doc:appunti:hardware:sjcam-8pro-custom-firmware [2023/06/09 05:16] – [SJCAM SJ8 Pro Custom Firmware] niccolo
+++ doc:appunti:hardware:sjcam-8pro-custom-firmware [2023/06/09 05:38] (current) – [My Custom firmware] niccolo
@@ Line 6: / Line 6: @@
 The main honorable mention goes to the hacker **VMax**, which created the software **[[https://github.com/vmax1145/BitrateEditor|BitrateEditor]]**.
+**WARNING**: The custom firmware presented in this page is based on the original **SJCAM SJ8 Pro firmware 1.3.2** and it was tested only on cameras shipped with that firmware. **Newer SJ8 Pros** are shipped with **a new firmware 1.4.x**, unfortunately SJCAM does not longer offer a firmware download service, so it was not possible to reverse engineer and eventually modify the new firmware. Also the old 1.3.2 disappeared from their download site and the procedure to upgrade firmware is not longer described in the support site. It is also suspected that the new models shipped with firmware 1.4.x are based on a different hardware that the 1.3.x ones, so using this firmware on newer cameras can be dangerous (**it can bricks the cam!**).
 See my other page about the SJCAM SJ8 Pro action camera:
@@ Line 15: / Line 17: @@
 ===== My Custom firmware =====
-Download the custom firmware here: **{{.:sjcam:sj8pro_mod-rigacci.org_v1.8_20220618.zip|sj8pro_mod-rigacci.org_v1.8_20220618.zip}}**.
+Download the custom firmware here:
+  * **{{.:sjcam:sj8pro_mod-rigacci.org_v1.8_20220618.zip|sj8pro_mod-rigacci.org_v1.8_20220618.zip}}**
 This is a breif list of customizations, see the README.txt contained into the archive for more details:
@@ Line 21: / Line 25: @@
   * Increased **bitrates**, as per other 4K action cameras. Particular attention to default settings and 1920x1080 mode.
   * Increased **keyframes** rates (reducing GOP-N): one keyframe every 1/4 second instead of 1 per second.
-  * **YUV color profiles**: all the three profiles **Default**, **SJCAM - Vivid** and **Flat** are made equals and neutral; multiplier is 1 and offset is zero for all the three Y, U and V components (shoul be actually Y, Cb and Cr when treating digital signals).
+  * **YUV color profiles**: all the three profiles **Default**, **SJCAM - Vivid** and **Flat** are made equals and neutral; multiplier is 1 and offset is zero for all the three Y, U and V components (shoul be actually Y, Cb and Cr when treating digital signals). This is because in my opinion the original Vivid is **too much saturated** and the FLAT is **too much washed out**, plus the management of the color profiles has some bugs and it is best to avoid fidding with them.
-  * Fixed **exposition** profiles: **Center**, **Spot** and **Average**.
+  * Fixed **exposition** profiles: **Center**, **Spot** and **Average** (Spot and Average are swapped into the original firmware!).
   * Changed **gamma curves**: added some brightness to shadows with an overall gamma coefficient of 1.10 and removed a slight red casting when using Auto White Balance in early hours of sunny days. All the gamma tables for video modes are the same, for photo modes we leaved a linear gamma (1.0) for R, G and B.
   * Change **chroma curves** to reduce banding in blue sky and to attenuate over-saturated colors.
-  * Changed power-on, power-off and photo shutter **sounds** with louder ones.
+  * Changed power-on, power-off and photo shutter **sounds** with **louder** ones.
   * Disabled **LRV** (low resolution videos) recording.