rigacci.org

User Tools

Site Tools

Trace:
doc:appunti:hardware:raspberrypi_nas_x835_sata_board

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
doc:appunti:hardware:raspberrypi_nas_x835_sata_board [2021/03/22 09:20] – [2.4 GHz WiFi and USB 3.0 interference problem] niccolodoc:appunti:hardware:raspberrypi_nas_x835_sata_board [2021/03/22 09:22] – niccolo
Line 1: Line 1:
 ====== Raspberry Pi NAS: The X835 board ====== ====== Raspberry Pi NAS: The X835 board ======
 +
 +This page is about using the **SupTronics X835** with the Raspberry Pi, to be used as NAS and mediacenter. See the main index at **[[raspberrypi_nas]]**.
  
 In January 2021 I purchased an HDD shield for the Raspberry Pi, it is the **[[http://www.suptronics.com/miniPCkits/x835.html|X835]]** model produced by **[[http://suptronics.com|suptronics.com]]**. It is not so cheap: I had to pay about **32 Euros** on Aliexpress for the bare board, without a power supply. The board can accomodate a **3.5 inches hard disk**. I wish to build an **home NAS** with integrated **multimedia center functions** based on **[[https://kodi.tv/|Kodi]]**. The output will go to an HDMI attached 32 inches display. In January 2021 I purchased an HDD shield for the Raspberry Pi, it is the **[[http://www.suptronics.com/miniPCkits/x835.html|X835]]** model produced by **[[http://suptronics.com|suptronics.com]]**. It is not so cheap: I had to pay about **32 Euros** on Aliexpress for the bare board, without a power supply. The board can accomodate a **3.5 inches hard disk**. I wish to build an **home NAS** with integrated **multimedia center functions** based on **[[https://kodi.tv/|Kodi]]**. The output will go to an HDMI attached 32 inches display.
doc/appunti/hardware/raspberrypi_nas_x835_sata_board.txt · Last modified: 2021/04/12 12:07 by niccolo