Differences

This shows you the differences between two versions of the page.

--- doc:appunti:hardware:raspberrypi_nas_smart_hard_disk [2025/10/10 11:16] – [udisks2.service] niccolo
+++ doc:appunti:hardware:raspberrypi_nas_smart_hard_disk [2025/10/10 11:24] (current) – [udisks2.service] niccolo
@@ Line 166: / Line 166: @@
 It seems that the **udisks2.service** may interfere with the hard disk spin-down feature. The ''man 8 udisks'' refers to setting APT options (//StandbyTimeout//, //APMLevel//, ...) via ATA commands.
-It is likely that the hdparm options set by **udev** on system start are overridden by udisks2. In a system based on RaspiOS 13 Trixie I had to remove the **udisks2** package to allow the hard drive to go into standby mode as epxlained above.
+It is likely that the hdparm options set by **udev** on system start are overridden by udisks2. In a [[..:software:kodi_installation_raspios_13|system based on RaspiOS 13 Trixie]] I had to remove the **udisks2** package to allow the hard drive to go into standby mode as epxlained above.
 Some useful udisks2 commands: