Differences

This shows you the differences between two versions of the page.

--- doc:appunti:hardware:raspberrypi_nas_audio [2021/03/11 10:53] – [Music Player Daemon] niccolo
+++ doc:appunti:hardware:raspberrypi_nas_audio [2025/10/13 09:16] (current) – [Digital audio through HDMI] niccolo
@@ Line 1: / Line 1: @@
 ====== Raspberry Pi NAS: The audio subsystem ======
+This page is about configuring the **audio subsystem** on a Raspberry Pi installed with RaspiOS, to be used as NAS and mediacenter. See the main index at **[[raspberrypi_nas]]**.
 I want to use **Kodi** for **HDMI video and audio** playback, but I want also occasionally to play music using **Music Player Daemon**, routing the audio to an external amplifier which has **RCA stereo connectors**. Once the cables are connected, it is also desiderable to play Kodi videos routing video to **HDMI monitor** and routing audio to the **stereo amplifier**.
@@ Line 15: / Line 17: @@
 {{ .:raspberrypi:raspberry-pi-hdmi-video-audio-cable.jpg?180|HDMI video and audio cable}}
-This is the first natuarl choiche, at least when watching videos using Kodi. I use an old **Raspberry Pi 3** as a Kodi media center, connected to an HDMI monitor capable of audio too; the sound quality is acceptable and it is aligned to the medium quality of the speakers inside the monitor. Unfortunately I discovered that the **Raspberry Pi 4** has a **worse audio quality** than the Pi 3: I ear continously **pops, clicks and little gaps in the music**. I tried to swap the power supply and the HDMI cable with better quality ones, but **the problem remains**. It seems that the problem is not hardware related, but it is introduced when I add Pulseaudio in the software stack. If I select direct Raspberry **PI:HDMI** as sound device in Kodi, the audio **playback is OK**.
+This is the first natural choiche, at least when watching videos using Kodi. I use an old **Raspberry Pi 3** as a Kodi media center, connected to an HDMI monitor capable of audio too; the sound quality is acceptable and it is aligned to the medium quality of the speakers inside the monitor. Unfortunately I discovered that the **Raspberry Pi 4** has a **worse audio quality** than the Pi 3: I ear continously **pops, clicks and little gaps in the music**. I tried to swap the power supply and the HDMI cable with better quality ones, but **the problem remains**. It seems that the problem is not hardware related, but it is introduced when I add Pulseaudio in the software stack. If I select direct Raspberry **PI:HDMI** as sound device in Kodi, the audio **playback is OK**.
 I prefer to avoid the HDMI audio output mainly because the audio of the HDMI monitor is of poor quality, but another problem is that if **the monitor goes into standby** (as Kodi does, when you don't play anything), also **the audio goes standby**. In this condition even the Music Player Damon cannot play to HDMI.
@@ Line 30: / Line 32: @@
 ==== Using an externa USB sound card ====
+{{ .:raspberrypi:raspberry-pi-usb-audio-cable.jpg?180|USB sound card with RCA connectors and cable}}
 For a decent audio quality, I decided that  the only acceptable solution is to relay on an external USB sound card connected to my stereo amplifier. I choosed a model based on the **C-Media Electronics** chip (USB Id **0d8c:0024**), which comes with two standard RCA connectors. The device is compatible with ALSA so the Pulseaudio system can select it per default, setting the following in **/etc/pulse/client.conf**: