doc:appunti:hardware:raspberrypi_nas_audio
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
doc:appunti:hardware:raspberrypi_nas_audio [2021/03/10 15:38] – [Audio hardware: Raspberry Pi 4] niccolo | doc:appunti:hardware:raspberrypi_nas_audio [2021/03/10 15:40] – [Use PulseAudio with Kodi] niccolo | ||
---|---|---|---|
Line 7: | Line 7: | ||
For the **hardware** part, you can use the **digital HDMI audio** or the **analog 3.5 mm jack** (which carries video and stereo audio signals over a CTIA 4 poles connector). For a **better audio quality** you have to connect and **audio hat** or an external **USB audio sound card**; as explained below the integrated audio devices are of unacceptable quality also for an occasional user, let alone an audiophile one! | For the **hardware** part, you can use the **digital HDMI audio** or the **analog 3.5 mm jack** (which carries video and stereo audio signals over a CTIA 4 poles connector). For a **better audio quality** you have to connect and **audio hat** or an external **USB audio sound card**; as explained below the integrated audio devices are of unacceptable quality also for an occasional user, let alone an audiophile one! | ||
- | ===== Raspberry | + | ===== Pi 4 audio hardware ===== |
+ | |||
+ | There are several possibilities of getting audio from a Raspberry Pi 4. | ||
==== Digital audio through HDMI ==== | ==== Digital audio through HDMI ==== | ||
Line 161: | Line 164: | ||
* **[[https:// | * **[[https:// | ||
- | ==== Use PulseAudio with Kodi ==== | + | ===== Use PulseAudio with Kodi ===== |
With the PulseAudio running as a system service, you can start Kodi and go to **Settings** => **System** => **Audio** = **Audio output device** and select **PULSE: Default**. Here you can also switch between HDMI and stereo jack: | With the PulseAudio running as a system service, you can start Kodi and go to **Settings** => **System** => **Audio** = **Audio output device** and select **PULSE: Default**. Here you can also switch between HDMI and stereo jack: |
doc/appunti/hardware/raspberrypi_nas_audio.txt · Last modified: 2021/03/22 09:27 by niccolo