doc:appunti:hardware:raspberrypi_micromediahub
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
doc:appunti:hardware:raspberrypi_micromediahub [2019/11/03 17:32] – [Kodi] niccolo | doc:appunti:hardware:raspberrypi_micromediahub [2020/09/28 18:45] (current) – [Kodi] niccolo | ||
---|---|---|---|
Line 9: | Line 9: | ||
* Joystick controller | * Joystick controller | ||
* LCD display 16x2 charaters | * LCD display 16x2 charaters | ||
+ | |||
+ | ====== Current consumption ====== | ||
+ | |||
+ | See **[[https:// | ||
+ | |||
+ | * **Raspberry Pi 3 Model B** | ||
+ | * 1GB RAM | ||
+ | * Typical bare-board active current consumption: | ||
+ | * Maximum total USB peripheral current draw: 1.2A | ||
+ | * Recommended PSU current capacity: 2.5A | ||
+ | * **Raspberry Pi 3 Model A+** | ||
+ | * 512MB LPDDR2 SDRAM | ||
+ | * Typical bare-board active current consumption: | ||
+ | * Maximum total USB peripheral current draw: Limited by PSU, board, and connector ratings only. | ||
+ | * **Toshiba Canvio Basics 1Tb** | ||
+ | * USB bus power (max. 900mA) | ||
====== Kodi ====== | ====== Kodi ====== |
doc/appunti/hardware/raspberrypi_micromediahub.1572802378.txt.gz · Last modified: 2019/11/03 17:32 by niccolo