doc:appunti:hardware:raspberrypi_micromediahub
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
doc:appunti:hardware:raspberrypi_micromediahub [2018/01/02 17:35] – [Problem Decoding Webm (VP8 Encoded) Videos] niccolo | doc:appunti:hardware:raspberrypi_micromediahub [2020/09/28 18:45] (current) – [Kodi] niccolo | ||
---|---|---|---|
Line 9: | Line 9: | ||
* Joystick controller | * Joystick controller | ||
* LCD display 16x2 charaters | * LCD display 16x2 charaters | ||
+ | |||
+ | ====== Current consumption ====== | ||
+ | |||
+ | See **[[https:// | ||
+ | |||
+ | * **Raspberry Pi 3 Model B** | ||
+ | * 1GB RAM | ||
+ | * Typical bare-board active current consumption: | ||
+ | * Maximum total USB peripheral current draw: 1.2A | ||
+ | * Recommended PSU current capacity: 2.5A | ||
+ | * **Raspberry Pi 3 Model A+** | ||
+ | * 512MB LPDDR2 SDRAM | ||
+ | * Typical bare-board active current consumption: | ||
+ | * Maximum total USB peripheral current draw: Limited by PSU, board, and connector ratings only. | ||
+ | * **Toshiba Canvio Basics 1Tb** | ||
+ | * USB bus power (max. 900mA) | ||
====== Kodi ====== | ====== Kodi ====== | ||
Line 20: | Line 36: | ||
Kodi will not start automatically at boot, just execute **kodi-standalone** from the command line. | Kodi will not start automatically at boot, just execute **kodi-standalone** from the command line. | ||
- | **NOTICE**: Raspbian | + | **NOTICE**: Raspbian |
+ | |||
+ | * **[[http:// | ||
+ | * **[[http:// | ||
+ | |||
+ | The first repository provides | ||
+ | |||
+ | Our current installation uses these versions: | ||
+ | |||
+ | ^ kodi | 2: | ||
+ | ^ kodi-bin | ||
+ | ^ kodi-eventclients-common | ||
+ | ^ kodi-eventclients-kodi-send | ||
+ | ^ kodi-peripheral-joystick | ||
+ | ^ libkodiplatform17: | ||
+ | To activate a joypad you have to go through **// | ||
===== Starting Kodi at Boot ===== | ===== Starting Kodi at Boot ===== | ||
doc/appunti/hardware/raspberrypi_micromediahub.txt · Last modified: 2020/09/28 18:45 by niccolo