Differences

This shows you the differences between two versions of the page.

--- doc:appunti:hardware:mini_pc_with_das [2024/04/29 07:36] – [Mini PC T9Plus with D4-300 TerraMaster DAS] niccolo
+++ doc:appunti:hardware:mini_pc_with_das [2024/04/29 09:55] – [Web References] niccolo
@@ Line 7: / Line 7: @@
 My home server is acting also as a domestic firewall (running Debian GNU/Linux), so I opted for a dual LAN Mini-PC. Obviously the only problem is the storage: the embedded SDD disk is not sufficient for my media library, so I opted for an esternal USB Direct Attached Storage. The choice was a **D4-300 TerraMaster DAS** which will host **two 4 Tb 3.5 inches drives** (leaving two empty slots).
-^ Mini PC T9Plus  ^^
+^  Mini PC T9Plus  ^^
 ^ CPU       | Intel(R) N95, 4 Cores  |
 ^ RAM       | 16 Gb  |
@@ Line 14: / Line 14: @@
 ^ WiFi      | Realtek RTL8852BE PCIe 802.11ax  |
 ^ Video     | Intel Alder Lake-N UHD Graphics  |
+^  D4-300 TerraMaster DAS  ^^
+^ Disk Slot Number       | 4  |
+^ Compatible Disk Types  | 3.5" SATA HDD\\ 2.5" SATA HDD\\ 2.5" SATA SSD  |
+^ USB                    | USB3.1 Type-C gen1 x 1  |
 ===== Installing Debian GNU/Linux =====
@@ Line 45: / Line 50: @@
 systemctl enable t9plus-leds.service --now
 </code>
+===== Always on =====
+Press **Del** at bootstrap time to enter the BIOS settings, go to the **Boot** page and set **State After G3** => **S0 State**.
+The ACPI power states are:
+  * S0: Normal Powered-On state (system working)
+  * S1: Standby
+  * S3: Suspend to Ram
+  * S4: Suspend to Disk
+  * S5: Shutdown state (soft off: some devices are still powered-on)
+  * G3: Mechanical off state
 ===== Reboot problem =====
@@ Line 151: / Line 169: @@
   * **[[https://superuser.com/questions/928741/how-can-i-check-whether-usb3-0-uasp-usb-attached-scsi-protocol-mode-is-enabled|How can I check whether USB3.0 UASP (USB Attached SCSI Protocol) mode is enabled in Linux?]]**
   * **[[https://unix.stackexchange.com/questions/347006/systemd-how-do-i-automount-a-usb-filesystem-using-etc-fstab|systemd: How do I automount a USB filesystem using /etc/fstab?]]**
+  * **[[t9plus_mini_pc_rgb_led_control]]**
   * **[[https://www.reddit.com/r/MiniPCs/comments/18icusg/t9_plus_n100_how_to_control_led/|T9 Plus N100 - How to control LED]]**
   * **[[https://github.com/thekief/s1t-ledcontrol|LED Controller]]**
   * **[[https://minipcunion.com/viewtopic.php?t=4424|Mini PC RGB AK1 Plus - Controllo RGB]]**