rigacci.org

User Tools

Site Tools

Trace: • Logical Volume Manager (LVM)
doc:appunti:hardware:lacie_d2_network_2

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Last revisionBoth sides next revision
doc:appunti:hardware:lacie_d2_network_2 [2011/03/24 10:21] – [EEPROM] niccolodoc:appunti:hardware:lacie_d2_network_2 [2014/01/28 09:20] – [Wake-On-LAN] niccolo
Line 213: Line 213:
  
 The Wake-On-LAN is **not handled by the U-Boot code** (like in the LaCie d2 Network). When the power switch is onto the ON position, the U-Boot always begins the boot process spinning-on the disk, during the boot process a script checks if the Deep Sleep Mode is active, in that case it halts the disk and wait for the Magic Packet. The Wake-On-LAN is **not handled by the U-Boot code** (like in the LaCie d2 Network). When the power switch is onto the ON position, the U-Boot always begins the boot process spinning-on the disk, during the boot process a script checks if the Deep Sleep Mode is active, in that case it halts the disk and wait for the Magic Packet.
 +
 +If you install a plain Debian operating system, you can use the **[[#fake_wake-on-lan|Fake Wake-On-LAN]]** software to simulate a Wake-On-LAN.
 ===== Installing Debian ===== ===== Installing Debian =====
  
Line 434: Line 436:
 </code> </code>
  
-==== Fake Wake-on-LAN ====+===== Fake Wake-on-LAN =====
  
 The Ethernet chip does not have WoL capabilities (whereas the old d2 Network does), so we can only simulate it. This is my first attempt to make a software Wake-on-LAN. The Ethernet chip does not have WoL capabilities (whereas the old d2 Network does), so we can only simulate it. This is my first attempt to make a software Wake-on-LAN.
  
-At an early stage of the boot process we suspend the disk and wait for a Magic Packet before to proceed. So the device is effectively powered and running, just the disk and the LED are turned off. I'm running the program with a Debian Squeeze installation. +At an early stage of the boot process the **''fake-on-lan''** program suspends the USB power, turn off the blue LED and suspend the disk. Then the program waits for a Wake-on-LAN Magic Packet or for a Power Button press/release before to proceed. The device is effectively powered-on and running the Linux kernel, just the USB, the LED and the disk are turned off. I'm running the program with a **Debian Squeeze** installation.
- +
-You can download the program here: **{{.:lacie:fake-on-lan-20110323.tar.gz|fake-on-lan-20110323.tar.gz}}**. +
- +
-This is the TODO list:+
  
-  * Turn off USB power too. +You can download the program here: **{{.:lacie:fake-on-lan-20110324.tar.gz|fake-on-lan-20110324.tar.gz}}**.
-  * Wake on power button keypress too. +
-  * Modify the standard halt sequence so it becomes a reboot followed by fake-on-lan, mybe using the relevant EEPROM bit.+
  
 ===== The EEPROM ===== ===== The EEPROM =====
doc/appunti/hardware/lacie_d2_network_2.txt · Last modified: 2014/01/28 09:22 by niccolo