doc:appunti:hardware:lacie_d2_network_2
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
doc:appunti:hardware:lacie_d2_network_2 [2011/03/24 10:59] – [Fake Wake-on-LAN] niccolo | doc:appunti:hardware:lacie_d2_network_2 [2014/01/28 09:20] – [Wake-On-LAN] niccolo | ||
---|---|---|---|
Line 213: | Line 213: | ||
The Wake-On-LAN is **not handled by the U-Boot code** (like in the LaCie d2 Network). When the power switch is onto the ON position, the U-Boot always begins the boot process spinning-on the disk, during the boot process a script checks if the Deep Sleep Mode is active, in that case it halts the disk and wait for the Magic Packet. | The Wake-On-LAN is **not handled by the U-Boot code** (like in the LaCie d2 Network). When the power switch is onto the ON position, the U-Boot always begins the boot process spinning-on the disk, during the boot process a script checks if the Deep Sleep Mode is active, in that case it halts the disk and wait for the Magic Packet. | ||
+ | |||
+ | If you install a plain Debian operating system, you can use the **[[# | ||
===== Installing Debian ===== | ===== Installing Debian ===== | ||
doc/appunti/hardware/lacie_d2_network_2.txt · Last modified: 2014/01/28 09:22 by niccolo