Differences

This shows you the differences between two versions of the page.

--- doc:appunti:hardware:lacie_d2_network_2 [2011/03/24 10:58] – [Fake Wake-on-LAN] niccolo
+++ doc:appunti:hardware:lacie_d2_network_2 [2011/03/24 10:59] – [Fake Wake-on-LAN] niccolo
@@ Line 434: / Line 434: @@
 </code>
-==== Fake Wake-on-LAN ====
+===== Fake Wake-on-LAN =====
 The Ethernet chip does not have WoL capabilities (whereas the old d2 Network does), so we can only simulate it. This is my first attempt to make a software Wake-on-LAN.
-At an early stage of the boot process the **''fake-on-lan''** program suspends the USB power, turn off the blue LED and suspend the disk. Then the program waits for a Wake-on-LAN Magic Packet or for a Power Button press/release before to proceed. The device is effectively powered-on and running the Linux kernel, just the USB, the LED and the disk are turned off. I'm running the program with a Debian Squeeze installation.
+At an early stage of the boot process the **''fake-on-lan''** program suspends the USB power, turn off the blue LED and suspend the disk. Then the program waits for a Wake-on-LAN Magic Packet or for a Power Button press/release before to proceed. The device is effectively powered-on and running the Linux kernel, just the USB, the LED and the disk are turned off. I'm running the program with a **Debian Squeeze** installation.
 You can download the program here: **{{.:lacie:fake-on-lan-20110324.tar.gz|fake-on-lan-20110324.tar.gz}}**.