Differences

This shows you the differences between two versions of the page.

--- doc:appunti:hardware:gl_ar750 [2021/05/10 08:56] – [VLAN limitations] niccolo
+++ doc:appunti:hardware:gl_ar750 [2023/09/11 07:37] (current) – niccolo
@@ Line 1: / Line 1: @@
 ====== GL-iNet GL-AR750 Travel AC Router ======
+{{gl-inet-gl-ar750.jpg?direct&260|GL-AR750}}
 === Default IP address and password ===
@@ Line 75: / Line 78: @@
 ===== VLAN limitations =====
-VLAN ID number is limited to FIXME
+There is a limit to **16 VLANs**, numbered from #0 to #15. Default configuration uses **VLAN #1** for **eth1.1** which is connected to bridge **br-lan**. This limitation is not visible from the LuCI web interface: any number greater than 15 will be silently accepted, but it will be not functional.
+You can view the actual switch configuration using:
+<code>
+swconfig dev switch0 show
+</code>
+You can check the limit issuing the following command (notice the error message):
+<code>
+swconfig dev switch0 vlan 16 set vid 16
+Failed to set attribute: Invalid input data or parameter
+</code>
 You cannot mix tagged and untagged VLAN on the same switch port.
+  * Only one port is allowed to carry untagged traffic for a specific VLAN.
+  * You cannot mix tagged and untagged VLAN on the same port. E.g. if a port carries untagged VLAN#10, the same port cannot carries tagged VLAN#11 (depending upon the order of the commands, the settings will be changed to carry buth as tagged).
+Limitation example #1: the **untagged VLAN#10** is **removed** from port **#1** and **#2**:
+<code>
+swconfig dev switch0 vlan 10 set ports "0t 1 2"
+swconfig dev switch0 vlan 11 set ports "0t 1 2"
+swconfig dev switch0 show
+...
+VLAN 10:
+        vid: 10
+        ports: 0t
+VLAN 11:
+        vid: 11
+        ports: 0t 1 2
+</code>
+Limitation example #2: the **untagged VLAN#10** is **changed to tagged** on **port #1** and it is removed from port **#2**:
+<code>
+swconfig dev switch0 vlan 10 set ports "0t 1 2"
+swconfig dev switch0 vlan 11 set ports "0t 1t 2"
+VLAN 10:
+        vid: 10
+        ports: 0t 1t
+VLAN 11:
+        vid: 11
+        ports: 0t 1t 2
+</code>
+===== Configuring a DMZ =====
+We used VLAN to configure a DMZ ... FIXME
 ===== Configuration =====
@@ Line 94: / Line 145: @@
 <code>
 opkg update
+# tcpdump-mini requires ??? kb:
 opkg install tcpdump-mini
+# coreutils-base64 requires 28 kb:
+opkg install coreutils-base64
+</code>
+=== Crontabs ===
+<code>
+crontab -e
+/etc/init.d/cron enable
+/etc/init.d/cron start
+ps | grep crond
 </code>