Differences

This shows you the differences between two versions of the page.

--- tecnica:motori:honda_ntv650_wiring_diagram [2025/10/21 10:24] – [Harness wires gauge] niccolo
+++ tecnica:motori:honda_ntv650_wiring_diagram [2025/10/24 17:52] (current) – [Honda NTV650 Revere - Wiring diagram] niccolo
@@ Line 3: / Line 3: @@
 Here it is the **wiring diagram drawn in color**. It was derived by me from a black and white printed diagram from Honda. Inspecting the original drawing I spotted two erros: there were two missing joints. Both were in the main harness, one on the green wires and the other in the white/green wires.
-{{.:honda_ntv650:honda-ntv650-revere-wiring-diagram.png?direct&600|Honda NTV650 Revere wiring diagram}}
+{{.:honda_ntv650:honda-ntv650-revere-wiring-diagram-0.4.0.png?direct&600|Honda NTV650 Revere wiring diagram}}
-Here it is the the PDF version: **{{.:honda_ntv650:honda-ntv650-revere-wiring-diagram.pdf|Honda NTV650 Revere wiring diagram (PDF)}}**.
+Here it is the the PDF version: **{{.:honda_ntv650:honda-ntv650-revere-wiring-diagram-0.4.0.pdf|Honda NTV650 Revere wiring diagram (PDF)}}**.
 ===== Headlight wiring =====
@@ Line 23: / Line 23: @@
 The outer diameter refers to the overall cable, including the insulator. The AWG gauge is calculated measuring the diameter of the single strand and calculating the overall cross-sectional area; then the nearest value is looked into the [[wp>American_wire_gauge|AWG gauge table]].
-**NOTICE**: The **19 AWG 30/34** notation means that there are 30 strands, each strand is an AWG #34 wire (0.160 mm diameter), the overall cross-section area is 0.60 mm², wich is almost an AWG #19 wire.
+**NOTICE**: The **19 AWG 30/34** notation means that there are 30 strands, each strand is an AWG #34 wire (0.160 mm diameter), the overall cross-sectional area is 0.60 mm², wich is almost an AWG #19 wire.
 **NOTICE**: The **ampacity** reported in the table is the maximum electrical current in amperes that the conductor can carry for **2 meters**, mantaining the **voltage drop below 2%**. The formulas for calculating the voltage drop for a copper conductor (coefficient ρ = 1.68*10^-8 Ωm) are:
@@ Line 76: / Line 76: @@
 {{.:honda_ntv650:ntv650-fuel-pump-connector-polarity.jpg?nolink&320|NT650 Revere - Fuel pump connector}}
-You will hear the noise from the working pump. Ance the carburetors are full, the pump will stop.
+You will hear the noise from the working pump. Once the carburetors are full, the pump will stop.
 ===== Connectors wires color =====