tecnica:motori:honda_ntv650_troubleshooting
This is an old revision of the document!
Table of Contents
Honda NTV650 Revere Troubleshooting
Spark unit
Green/White | Ground | It connects to the ground when it is OK to run the engine. Goes to the clutch switch, the side stand switch and the neutral switch diode. |
---|---|---|
Yellow/Blue | Goes to the ignition coil. | |
Black/White | +12V | It gets the +12V through fuse #6 when the engine switch is on the RUN position and the ignition switch is ON. Goes to the ignition coils and to the engine stop switch. |
Blue/Yellow | Goes to the ignition coil. | |
Green | Ground | Always connected to the ground. |
Light blue/Red | Ground | It connects to the ground when the gear is in neutral position. Goes to the neutral switch. |
Starter relay switch
Green/Red | Ground | It gets the ground when is it OK to start the engine. Goes to the clutch switch, to the side stand switch and to the neutral switch diode. |
---|---|---|
Yellow/Red | +12V | It gets the +12V through fuse #6 when the start button is pressed. Goes to the starter switch. |
Fuel pump relay and fuel pump
Blue/Black | +12V | It gets the +12V when the relay is switched-on (the engine is running). Goes from the fuel cut relay to the fuel pump. |
---|---|---|
Black | +12V | It gets the +12V when the ignition switch is ON. It goes to the fuse #6. |
Yellow/Blue | It gets the signal from the ignition coils (is it + or -?) to switch-on the relay. It goes to the spark unit. |
tecnica/motori/honda_ntv650_troubleshooting.1725872518.txt.gz · Last modified: 2024/09/09 09:01 by niccolo