doc:appunti:hardware:raspberrypi_wpa_supplicant_problem
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
doc:appunti:hardware:raspberrypi_wpa_supplicant_problem [2018/02/17 09:08] – niccolo | doc:appunti:hardware:raspberrypi_wpa_supplicant_problem [2020/08/14 08:17] (current) – niccolo | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== | + | ====== |
I got a problem with a **Realtek RTL8188EUS** UBS WiFi dongle, into a **Raspberry Pi Model A+**, running **Rasbpian 2017-11-29 Stretch Lite** (based on Debian 9.1). | I got a problem with a **Realtek RTL8188EUS** UBS WiFi dongle, into a **Raspberry Pi Model A+**, running **Rasbpian 2017-11-29 Stretch Lite** (based on Debian 9.1). | ||
Line 47: | Line 47: | ||
Notice that the configuration file used is **/ | Notice that the configuration file used is **/ | ||
+ | |||
+ | ===== Alternative: | ||
+ | |||
+ | The default is to start **wpa_supplicant** via **dhcpcd**, as seen above. But if you want, you can force **systemd** to start the service independently. | ||
+ | |||
+ | You have to start the // | ||
+ | |||
+ | < | ||
+ | mv / | ||
+ | systemctl enable wpa_supplicant@wlan0.service | ||
+ | </ | ||
+ | |||
+ | After a reboot you should see the wpa_supplicant process running, and dhcpcd will configure wlan0 happily. | ||
+ | ===== Web References ===== | ||
+ | |||
+ | * [[https:// |
doc/appunti/hardware/raspberrypi_wpa_supplicant_problem.txt · Last modified: 2020/08/14 08:17 by niccolo