Differences

This shows you the differences between two versions of the page.

--- doc:appunti:hardware:qnap_ts-120 [2022/02/11 17:28] – [Real Time Clock rtc0] niccolo
+++ doc:appunti:hardware:qnap_ts-120 [2022/02/12 07:04] – [Serial Console] niccolo
@@ Line 95: / Line 95: @@
 </code>
-===== Console seriale =====
+===== The Serial Console =====
-Vedere qui: [[http://www.cyrius.com/debian/kirkwood/qnap/ts-119/serial/]]
+{{ .:qnap:qnap-ts-120-serial-console-jtag.jpg?direct&400|QNAP TS-120: Console connector}}
+{{ .:qnap:qnap-ts-120-serial-console-closeup.jpg?direct&160|Serial Console JTAG Connector}}
+On the circuit board of the QNAP TS-120 there is a JTAG connector for the serial console. I used an old CD-ROM audio cable because it had the right connector. I wired only the **GND**, **TX** and **RX** pins from to QNAP to a serial-to-USB adapter. The adapter was inserted intp a GNU/Linux computer running the **minicom** program. The speed of the serial line was set to **115200**. The connector pinout is documented in this page: [[http://www.cyrius.com/debian/kirkwood/qnap/ts-119/serial/|Serial console for QNAP TS-11x/TS-12x]].
-I connected only the **GND**, **TX** and **RX** pins from to QNAP to a serial-to-USB adapter. The adapter was inserted intp a GNU/Linux computer running the **minicom** program. The speed of the serial line was set to **115200**.
+^ Console Pinout  ^^
+^ 1  | TX        |
+^ 2  | VCC +3.3  |
+^ 3  | RX        |
+^ 4  | GND       |
+This is the boot process captured from the serial line:
+<code>
+         __  __                      _ _
+        |  \/  | __ _ _ ____   _____| | |
+        | |\/| |/ _` | '__\ \ / / _ \ | |
+        | |  | | (_| | |   \ V /  __/ | |
+        |_|  |_|\__,_|_|    \_/ \___|_|_|
+ _   _     ____              _
+| | | |   | __ )  ___   ___ | |_
+| | | |___|  _ \ / _ \ / _ \| __|
+| |_| |___| |_) | (_) | (_) | |_
+ \___/    |____/ \___/ \___/ \__|  ** LOADER **
+ ** MARVELL BOARD: DB-88F6282A-BP LE TS-120 ,PHY=1.8v
+U-Boot 1.1.4 (Nov  5 2012 - 17:39:47) Marvell version: 3.5.3
+U-Boot code: 00600000 -> 0067FFF0  BSS: -> 006CD5C0
+Soc: MV88F6282 Rev 1CPU running @ 1600Mhz L2 running @ 533Mhz
+SysClock = 533Mhz , TClock = 200Mhz
+</code>
 ===== Real Time Clock rtc0 =====