doc:appunti:hardware:alicegate_agpwi_wifi_n
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
doc:appunti:hardware:alicegate_agpwi_wifi_n [2018/07/09 14:40] – [Flashing the Comtrend Firmware] niccolo | doc:appunti:hardware:alicegate_agpwi_wifi_n [2018/11/18 21:17] (current) – [Alternative Firmware Comtrend A731-406CTL-T01_R08] niccolo | ||
---|---|---|---|
Line 100: | Line 100: | ||
===== Alternative Firmware Comtrend A731-406CTL-T01_R08 ===== | ===== Alternative Firmware Comtrend A731-406CTL-T01_R08 ===== | ||
+ | |||
+ | FIXME This firmware is **buggy too**. It does not keep the wlan config status across reboot: I set it to disables and I find it enabled again. Verified via web interface and with **%%wlan info --config%%** on command line. | ||
{{.: | {{.: | ||
Line 129: | Line 131: | ||
? | ? | ||
sys reboot | sys reboot | ||
+ | </ | ||
+ | |||
+ | < | ||
+ | > adsl info | ||
+ | adsl: ADSL driver and PHY status | ||
+ | Status: Showtime | ||
+ | Retrain Reason: 8000 | ||
+ | Last initialization procedure status: | ||
+ | Max: Upstream rate = 319 Kbps, Downstream rate = 3264 Kbps | ||
+ | Bearer: 0, Upstream rate = 323 Kbps, Downstream rate = 2986 Kbps | ||
+ | </ | ||
+ | |||
+ | < | ||
+ | > lan show | ||
+ | br0 Link encap: | ||
+ | inet addr: | ||
+ | inet6 addr: fe80:: | ||
+ | UP BROADCAST RUNNING MULTICAST | ||
+ | RX packets: | ||
+ | TX packets: | ||
+ | collisions: | ||
+ | RX bytes: | ||
</ | </ | ||
===== Web Resources ===== | ===== Web Resources ===== |
doc/appunti/hardware/alicegate_agpwi_wifi_n.txt · Last modified: 2018/11/18 21:17 by niccolo